Path Outages

An outage of a central network component can cause a lot of node outages. Path Outages can be used to suppress notifications based on how nodes depend on each other in the network which are defined in a Critical Path. The Critical Path needs to be configured from the network perspective of the monitoring system. By default, the Path Outage feature is disabled and has to be enabled in the poller-configuration.xml.

The following image shows an example network topology.

02 path outage
Figure 1. Path Outage example

From the perspective of the monitoring system, a Router named default-gw-01 is on the critical path to reach two networks. If router default-gw-01 is down, it is not possible to reach any node in the two networks behind and they will be all unreachable as well. In this case, an administrator would like to have just one notification for default-gw-01 and not for all the other nodes behind it. Building this configuration in Meridian requires the following information:

  • Parent Foreign Source: The Foreign Source where the parent node is defined.

  • Parent Foreign ID: The Foreign ID of the parent node where this node depends on.

  • The IP Interface selected as Primary is used as Critical IP.

In this example we have created all nodes in a requisition named Network-ACME and we use the node label value as the Foreign ID.

In the Web UI go to Gear Menu  Manage Provisioning Requisitions  Edit the Requisition  Edit the Node  Path Outage to configure the network path by setting the Parent Foreign Source, Parent Foreign ID and Provisioned Node.

Table 1. Provisioning for Topology Example
Parent Foreign Source Parent Foreign ID Provisioned Node

not defined

not defined

default-gw-01

Network-ACME

default-gw-01

node-01

Network-ACME

default-gw-01

node-02

Network-ACME

default-gw-01

default-gw02

Network-ACME

default-gw-02

node-03

Network-ACME

default-gw-02

node-04

The IP Interface which is set to Primary is selected as the Critical IP. In this example, it is important that the IP interface on default-gw-01 in the network 192.168.1.0/24 is set as Primary interface. The IP interface in the network 172.23.42.0/24 on default-gw-02 is set as Primary interface.